beautypg.com

Ip packet processing commands, A-16 – Paradyne Hotwire 6342 User Manual

Page 82

background image

A. Command Line Interface

A-16

May

2001

6371-A2-GB20-20

IP Packet Processing Commands

IP multicast

{

enable

|

disable

}

Minimum Access Level: Administrator
Command Mode: Config

Enables or disables the forwarding of IP multicast packets. This setting is retained across
power cycles.

enable – Enable forwarding of IP multicast packets.

disable – Disable forwarding of IP multicast packets. The default is disable.

IP routing

{

enable

|

disable

}

Minimum Access Level: Administrator
Command Mode: Config

Enables or disables routing capability for traffic in the service domain so the device
operates as a router (gateway) or a bridge.

NOTE: IP routing of traffic in the management domain is unaffected by this command;
IP routing is always enabled for management domain traffic.

enable – Enable IP routing for traffic in the service domain; the router operates as a
gateway. If upgrading software to R3, the default is enable so the router’s current
functionality is retained.

disable – Disable IP routing for traffic in the service domain. The default is disable.

packet processing

{

enable

|

disable

}

Minimum Access Level: Administrator
Command Mode: Config

Enables or disables the processing of all service domain packets, including IP packets.
This setting is retained across power cycles.

enable – Enable processing of packets. The default is enable.

disable – Disable processing of packets.

This manual is related to the following products: