Paradyne Hotwire 6342 - Manual (Page 85)

A. Command Line Interface
6371-A2-GB20-20 May 2001 A-19
show bridge
Minimum Access Level: Operator
Command Mode: Standard
Displays the bridge configuration and forwarding database.
Sample show bridge display:
Bridging – disabled
Spanning tree – enabled
Configured aging timeout: 300 seconds
Filtering database entries:
MAC addr action interface timeout (sec.)
xx:xx:xx:xx:xx:xx xxxxxxx xxxxxx xxxxxxxxxxxx
NOTES:
– Action can be discard or forward.
– Timeout can be Permanent, the number of seconds left before the entry is aged out
and goes away, or <1 (less than a second).
show config
Minimum Access Level: Operator
Command Mode: Standard
Sample show config display:
syslog {enabled | disabled}
eth1 frame {DIX | 802.3}
proxy ARP eth1 {enabled | disabled}
proxy ARP dsl1 {enabled | disabled}
basic NAT {enabled | disabled}
NAPT {enabled | disabled} or NAT disabled *
DHCP server {enabled | disabled}
DHCP relay {enabled | disabled}
bridging {enabled | disabled}
IP routing {enabled | disabled}
IP multicast {enabled | disabled}
packet processing {enabled | disabled}
dsl1 1483 encapsulation {LLC | VC Muxing}
autologout {enabled | disabled}
* NAT disabled only appears when both forms of NAT are disabled.
show console
Minimum Access Level: Operator
Command Mode: Standard
Displays either console enabled or console disabled .
show dhcp relay
Minimum Access Level: Operator
Command Mode: Standard
Displays the DHCP relay agent’s current status and configuration.
Sample show dhcp relay display:
DHCP relay – { enabled | disabled }
DHCP relay – server ip-addr: x.x.x.x
Maximum number of DHCP relay clients: xxx