Show statistics [ eth1 | dsl1 | ip | bridge, Show statistics eth1, Show statistics dsl1 – Paradyne Hotwire 6342 User Manual
Page 89

A. Command Line Interface
6371-A2-GB20-20
May 2001
A-23
show statistics
[
eth1
|
dsl1
|
ip
|
bridge
]
Minimum Access Level: Operator
Command Mode: Standard
Displays the specified set of statistics. If no set is specified, ALL statistics for the router
are shown.
eth1 – Ethernet interface statistics.
dsl1 – DSL interface statistics.
ip – IP processing statistics.
bridge – Bridge statistics.
show statistics eth1
The following statistics are displayed for
show statistics eth1
:
eth1 statistics:
Total Bytes Received
nnnn
Total Bytes Transmitted
nnnn
Total Frames Received
nnnn
Total Frames Transmitted
nnnn
Single Collision on Tx
nnnn
Multiple Collision on Tx
nnnn
Late Collision on Tx
nnnn
No Carrier Detect on Tx
nnnn
Pauses on Tx
nnnn
Defers on Tx
nnnn
Total Frames Discarded
nnnn
Zero valued discards are not shown
Refer to
Table 5-1, Reasons for Ethernet Interface (eth1) Discarded Frames,
Monitoring the DSL Router, for additional information.
show statistics dsl1
The following statistics are displayed for the DSL interface
show statistics dsl1
:
dsl1 statistics:
Service Domain Statistics:
(end-user traffic)
Total Bytes Received
nnnn
Total Bytes Transmitted
nnnn
Total Frames Received
nnnn
Total Frames Transmitted
nnnn
Management Domain Statistics
:
(management traffic)
Total Bytes Received
nnnn
Total Bytes Transmitted
nnnn
Total Frames Received
nnnn
Total Frames Transmitted
nnnn
Total Frames Discarded
nnnn
Zero valued discards are not shown
Table 5-2, Reasons for DSL Interface (dsl1) Discarded Frames,
Monitoring the DSL Router, for additional information.
(Continued on next page.)