Philips DVDR80/99 - Manual (Page 33)

Channel Programming 33
In the brief period between your Initial Setup of the Recorder and the
setup of the GUIDE Plus+
® System, you can adjust the TV channel listings.
This option will not be available for selection once the GUIDE Plus ® System
is in use and receiving programming data.The GUIDE Plus ® System will
override any channel settings you make manually.
1 Press SYSTEM MENU. Press ; to select in the top left
corner of the Menu Bar at the top of the TV screen.
2 Press 9CH- repeatedly to select at the end of the second
menu page. Press :.
3 Press 8CH+ or 9CH- to select Auto Ch. Programming,
then press OK. “Searching for TV channels” will appear, along with
a scale showing channels that are being memorized.The number of
channels found will show on the screen as the searching progresses.
This will take a few minutes, depending on the channels available.
4 When the channel search finishes, “Auto ch. search complete” will
appear, along with the total number of channels found.
Press SYSTEM MENU. The Installation menu will reappear.
If you are satisfied with the channels found, press SYSTEM
MENU again to remove the menu. You are finished.
To add or delete additional channels, press 8CH+ or 9CH-
to select Add/Delete Channels, then go to step 5.
5 Press :. A channel list will appear. Beside each channel number,
you will see “Delete” or “Add.”
6 Press 8CH+ or 9CH- to select the channel number you
want to add or delete, then press ; or : to choose Add or
Delete for that channel. Press OK to store your choice.
Repeat to add or delete other channels.
7 Press SYSTEM MENU repeatedly to remove all the menus
when you are finished.
Installation
Add/Delete Channels
K K ...
u Channel 001 s Delete B
L Channel 002 Add
Channel 003 Add
Channel 004 Add
Channel 005 Add
Channel 006 Add
L...
To exit press
SYSTEM MENU
Installation
K
u B Auto Ch. Programming B
L Add/Delete Channels
Time/Date
Cable/Antenna
To exit press
SYSTEM MENU
• Only added channels are
accessible using CH+8/CH-9.
Select deleted channels with
the Number buttons instead.
• The Recorder detects whether
you have an Antenna or Cable
TV signal. If you are receiving
limited channels, check the
Cable/Antenna setting. Follow
steps 1-2 above. Press CH-9
to choose Cable/Antenna, then
press OK. Press CH+8 or CH-
9 to choose Cable or Anten.
Press OK, then press SYSTEM
MENU. Press OK again to
reset the channels.When the
channel search ends, press
SYSTEM MENU.This is not
available once the GUIDE
Plus+
® System controls the
channel list.
Helpful Hints
STANDBY
REC/OTR
TIMER REC MODE PLAY MODE TV/DVD
MONITOR
•TV
DIM RETURN T/C
DISC MANAGER FSS SELECT
SUBTITLE
STOP TV VOLUME
PAUSE SLOW
PLAY
AUDIO ANGLE ZOOM
GUIDE/TV
MUTE CLEAR
`
E
CH CH-
CH CH+
OK
SYSTEM
DISC DISC
Ç
H G k
MENU
1-6
1,4,7