Setup as pop3 client, Pre installation information – Panasonic DP-6010 User Manual
Page 109
Pre Installation Information
109
Inter
n
et Fax
F
eat
u
re
s
To install your machine as POP3 Client, the following network parameters need to be programmed on your
network.
• TCP/IP Address of your machine
• TCP/IP Subnet Mask of your machine
• TCP/IP Address of the Default Gateway
• TCP/IP Address of the DNS Server (if not available, see note 2)
• Email Address of your machine (see note 1)
• Name or IP Address of the Default SMTP mail server
• POP Server Name or IP Address
• POP User Account Name
• POP Password
Email Transmission (from your machine to a PC)
Email reception (from a PC to your machine)
NOTE
1. The email address format can be the same as your regular email address. If your email
address is [email protected], your machine's email address can be
[email protected].
2. By default the machine requires the IP Address of the DNS Server and prompts you to enter
the SMTP and POP Server Names.
If the DNS Server is not available, change the 26 (DNS server address) of General Settings to
"No" (
, Input ID Code,
.). Then the machine will prompt you to enter the IP
Address of the SMTP and POP Servers.
Setup as POP3 Client
SMTP01.panasonic.com
(SMTP Mail Server)
POP02.panasonic.com
(POP Server)
Gateway(Router)
SMTP
POP3
SMTP01.panasonic.com
(SMTP Mail Server)
POP02.panasonic.com
(POP Server)
Gateway(Router)
SMTP
POP3
FUNCTION
GENERAL SETTINGS
04 Key Operator Mode
OK 26 DNS server address