Panasonic PT-D10000E - Manual (Page 82)

82 – ENGLISH
Setting the startup logo
This sets the startup logo that is projected when the
power is turned on.
1. Press ▲▼ to select “STARTUP
LOGO”.
2. Press ◄► to switch “STARTUP
LOGO”.
The setting will change as follows each time
◄► is pressed.
LOGO3 OFF
LOGO2 LOGO1
LOGO3:
The Panasonic logo and DIGITAL
PROJECTOR logo are projected.
OFF:
No startup logo is projected.
LOGO1:
The picture registered by the user will be
projected.
LOGO2:
The picture registered by the user will be
projected.
Note
Separate software is required in order to create the
pictures to use for “LOGO1” and “LOGO2”. Consult
your dealer.
•
•
•
•
•
•
OPTION2
PROJECTOR ID
INSTALLATION
ALTITUDE
DIRECTION
LAMP SELECT
LAMP RELAY
RS-232C
SYSTEM INFORMATION
AIR FILTER CLEANING
DATE AND TIME
STARTUP LOGO
PASSWORD
MENU SELECT
CHANGE
2
FRONT-F
LOW
H
QUAD
OFF
LOGO1
OPTION2
PROJECTOR ID
INSTALLATION
ALTITUDE
DIRECTION
LAMP SELECT
LAMP RELAY
RS-232C
SYSTEM INFORMATION
AIR FILTER CLEANING
DATE AND TIME
STARTUP LOGO
PASSWORD
MENU SELECT
CHANGE
2
FRONT-F
LOW
H
QUAD
OFF
LOGO1
Password
This function is used by a service person.
Input the password with the numeric buttons (0 to 9)
of the remote control and press ENTER to confirm the
entry.
Option2 settings (continued)