Installation procedure, English – Panasonic PT-D10000E User Manual
Page 112
112
– ENGLISH
When installing the ceiling mount bracket to the projector, install the accessory eye bolts and wires to the projector.
(The projector will still be safe if they are not used, however they will help prevent the possibility of accidents
caused by the projector falling down if the screws happen to become loose.)
Installation should be carried out by a qualified technician by following the procedure given below.
Panasonic takes no responsibility for any losses or damage occurring as a result of using a ceiling mount bracket
not manufactured by Panasonic, or if damage to the projector occurs as a result of an inappropriate location used
for installing the ceiling mount bracket, even if the projector's warranty period has not yet expired.
Use a torque screwdriver or similar tool to tighten the screws. Do not use tools such as electric screwdrivers or
impact screwdrivers.
Dispose of any used products as soon as possible by asking a qualified technician for assistance.
Attention
Be sure to use the accessory eye bolts and wires.
Installation procedure
•
•
•
•
1. Place the projector on a soft cloth
with the base facing upward.
2. Turn the four adjustable feet
counterclockwise and remove
them from the projector.
The adjustable feet will be used if the projector is
installed normally, so store them safely.
Adjustable feet
3. Turn the four eye bolts clockwise
to install them to the projector.
Eye bolt
4. Install each of the four wires to the
four eye bolts.
5. Pull the four accessory wires from
the eye bolts to the ceiling in four
directions.
Wire
Eye bolt
1. Place the projector on a soft cloth
with the base facing upward.
2. Turn the four adjustable feet
counterclockwise and remove
them from the projector.
The adjustable feet will be used if the projector is
installed normally, so store them safely.
Adjustable feet
3. Turn the four eye bolts clockwise
to install them to the projector.
Eye bolt
4. Install each of the four wires to the
four eye bolts.
5. Pull the four accessory wires from
the eye bolts to the ceiling in four
directions.
Wire
Eye bolt
Notes when installing the ceiling mount bracket