Panasonic PT-D10000E - Manual (Page 43)

Basic Operation
ENGLISH – 43
Using the SHUTTER
function
If the projector is not used for a certain period of
time during the meeting intermission, for example, a
shutter mode is available that allows the user to hide
images temporarily.
1. Press SHUTTER on the remote
control or the main unit.
The image is turned off.
2. Press SHUTTER again.
The image comes back.
On-screen display
function
This turns the on-screen display function on and off.
1. Press ON SCREEN on the
remote control.
•
•
Switching the input signal
You can use the remote control to switch the signals
that are being input and projected.
1. Press INPUT SELECT on the
remote control or the main unit.
Press RGB1:
Switches to RGB1 input.
Press RGB2:
Switches to RGB2 input.
Press DVI-D:
Switches to DVI-D input.
Press VIDEO:
Switches to video input.
Press S-VIDEO:
Switches to S-VIDEO input.
Press AUX:
Switches to optional input module input.
(The AUX button to switch the input is
disabled when an optional input module is not
connected.)
Note
Refer to “Connection” for details on the input
terminals. (pp. 25, 26)
Status function
This shows the projector status. It can also be used
to send information about the projector’s status via
e-mail.
1. Press STATUS on the remote
control.
Note
Refer to “How to use network function” for details.
(pp. 84-97)
•
•
•
•
•
•
•
•
STATUS
INPUT : RGB1
: 0.00kHz/ 0.00Hz
PROJECTOR RUNTIME : 13h
LAMP1 : 9h/OFF/
LAMP2 : 10h/OFF/
LAMP3 : 9h/OFF/
LAMP4 : 9h/ON/
TEMP : IN- 27 / OUT- 32 /OPT- 36
VERSION MAIN : 0.55
VERSION NETWORK : 0.09
REMOTE2 : DISABLE
END STATUS VIA E-MAIL ENTER
STATUS
INPUT : RGB1
: 0.00kHz/ 0.00Hz
PROJECTOR RUNTIME : 13h
LAMP1 : 9h/OFF/
LAMP2 : 10h/OFF/
LAMP3 : 9h/OFF/
LAMP4 : 9h/ON/
TEMP : IN- 27 / OUT- 32 /OPT- 36
VERSION MAIN : 0.55
VERSION NETWORK : 0.09
REMOTE2 : DISABLE
END STATUS VIA E-MAIL ENTER
Basic operations using the remote control
FUNC1
ON
SCREEN
LIGHT
TEST
PATTERN
ASPECT
SHUTTER
INPUT
SELECT
AUTO
SETUP
STATUS