Panasonic PT-D10000E - Manual (Page 34)

34 – ENGLISH
Projection
Power indicator lamp
This shows the power supply status. Make sure
that you fully understand the operation of the power
indicator lamp before operating the projector.
Attention
While the projector is in standby preparation mode
(when the power indicator lamp is lit orange), the
internal fan is running to cool down the projector. Do
not turn off the MAIN POWER switch or disconnect
the power cord at this time.
Note
If the POWER ON “ | ” button is pressed while the
projector is still in standby preparation mode, it may
take some time before the projector is ready to
project pictures.
The cooling fan will still be operating and the
projector will still be drawing approximately 25 W of
power while the projector is in standby mode (when
the power indicator lamp is lit red).
•
•
•
Indicator
status
Projector status
Off Main power is off
Red Lit
Standby mode
POWER ON (|) button can be pressed
so that images can be projected.
Green Lit Images are being projected (on)
Orange Lit
Standby preparation mode
After a short while, the projector will
switch to standby mode.
Indicator
status
Projector status
Off Main power is off
Red Lit
Standby mode
POWER ON (|) button can be pressed
so that images can be projected.
Green Lit Images are being projected (on)
Orange Lit
Standby preparation mode
After a short while, the projector will
switch to standby mode.
Connecting the power
cord
Insert the accessory power cord securely into the
projector and the electrical outlet.
Be sure to read the “IMPORTANT SAFETY NOTICE”
(pp. 4-5) and “Precautions with regard to safety”
(pp. 6-9) for details on handling the power cord.
Installation
1. Check the shape of the AC
IN terminal on the side of the
projector and the shape of the
power cord connector, and
insert the power cord securely
into the AC IN terminal.
2. Insert the power cord plug into
an electrical outlet.
Removal
1. Check that the MAIN POWER
switch on the projector is at
the OFF position, and then
disconnect the power cord plug
from the electrical outlet.
2. Disconnect the power cord
connector from the AC IN
terminal of the projector.
Attention
Connect all peripheral equipment to the projector
before connecting the projector’s power cord.
(pp. 25-26)
■
■
•
FILTER
CLEANING
OPEN
CLOSE
Power indicator lamp