Pitney Bowes W680 - Manual (Page 41)

Pitney Bowes W660/W680 Operator Guide 3-13
W660/W680 Basics • 3
Setting Up A
Job (continued) 6. Adjust the Position of the Feed Ramp
With a stack of material loaded:
1. Loosen the lock knob that holds the feed ramp in posi-
tion.
2. Lower the feed ramp until the top of the bottom piece of
the stack reaches the middle of the feed ramp.
3. Tighten the feed ramp's lock knob to hold it in position.
At this point, it's a good idea to recheck your setup adjustments:
• Is the separator gap adjustment correct?
• Is the wireframe centered under the material?
• Is the feed angle okay?
• Is there a slight clearance between the sliding fence and
the edge of the stack?
Feed Ramp