Pitney Bowes W680 - Manual (Page 22)

2-10 Pitney Bowes W660/W680 Operator Guide
2 • Setting Up the W660/W680 Printer
Connecting the
W660/W680
to Your
Computer 4. Connecting the Parallel Cable or Serial Cable
Use the parallel cable supplied to connect the W660/W680 to
your computer, or use an approved serial cable.
Each end of the parallel cable has a connector. One end is labelled
“Printer” and the other is labelled “Computer.”
1. To connect the Parallel Cable to the printer, align the end
of the cable connector labelled “Printer” with the parallel
port on the interface panel at the rear of the printer. (See
the figure below.) Push the cable connector into the port.
Serial Port
Power Receptacle
Fuse
Power Switch
Parallel Port