Pitney Bowes W680 - Manual (Page 35)

Pitney Bowes W660/W680 Operator Guide 3-7
W660/W680 Basics • 3
Setting the Separator Gap
Setting Up A
Job (continued)
Lock Knob
H-Block Separator
Place a
sample piece
against the
input wall and
between the
separator
fingers and the
feed roller
Support Plate
NOTE: If the separator gap is not set properly, the printer
will misfeed or jam. If the gap is to big, the printer will feed
doubles (two or more pieces at the same time). If the gap is
too small, material will jam at the feed roller entrance. If
you're running post cards and have feeding problems, set a
smaller gap between the H-Block separators and feed rollers,
or use thinner media.
5. Lock each separator in place.