Palm T5 - Manual (Page 601)

Tungsten™ T5 Handheld 579
CHAPTER 27 Maintaining Your Handheld
• Use only 3.5 mm stereo headphones in your handheld’s headphone jack.
• Be sure to get rid of any static electricity buildup before you connect your handheld to any cable
or accessory.
Handheld don’ts
• Do not drop, bang, or otherwise cause a strong impact to your handheld.
• Do not carry your handheld in your back pocket; you might sit on it by mistake.
• Do not let your handheld get wet; don’t even leave it in a damp location.
• Do not expose your handheld to very hot or cold temperatures, including placing it near a
heater, leaving it in a car, or setting it by a window in direct sunlight.
Resetting your handheld
On rare occasions your handheld may not respond when you press a button or tap the screen. In
this case, you need to reset your handheld.
Doing a soft reset
A soft reset tells your handheld to stop what it’s doing and start over again. None of your
information will be lost. After a soft reset, a screen appears that lets you reset the date and time, if
needed.
To do a soft reset, unscrew the top of the stylus to access the reset tool (or find a similar object
without a sharp tip) and gently press the reset button inside the hole on the back panel of your
handheld.