Panasonic UB-5325 - Manual (Page 9)

Part Names and Functions
9
English
■ Control panel
Panel Name Description
Contrast/
Remaining
Film
Indicator
This lamp indicator notifies the user when the time to replace the
thermal transfer film is approaching (estimated) and of the
printing contrast used during copying.
Indicator off:
Normal printing contrast
Indicator on: Darker than normal printing contrast
Indicator flashing*: Almost time to replace the thermal transfer
film
(Note that only about 15 more sheets may be
copied when this indicator starts flashing.)
Replacement film (UG-6001) is separately available
from the dealer where you purchased your unit.
* The flashing indicator will go out after the power is turned off, or the
printer has been opened and closed. (When copying is performed, this
indicator will begin flashing again.)
Contrast
Key Each time this key is pressed, the unit will alternate between
normal and dark contrast modes (Normal/Dark).
2-Screen
Copy Key This key causes the front and back of the screen to be copied on
a single sheet of paper.
Multi-Copy/
Error
Indicator
This indicator displays the number of copies to be made. The
display changes each time the Multi-Copy/Stop Key is pressed.
Example: 1
→ 2 → ··· → 9 → 1 → ···
When an error occurred, a flashing symbol will appear in this display to
indicate the error status. (See page 27.)
Multi-Copy/
Stop Key
When making multiple copies, press this key until the desired
number of copies is displayed on the Multi-Copy/Error Indicator.
This key can also be pressed to stop copying while executing
multiple copies.
• The display changes as shown below each time the screen is copied. After
reaching 0, the display will reset to 1.
Example: 5 → 4 → 3 → 2 → 1 → 0 → 1
(Number is counted down.)
Copy Key This key causes the screen to be copied.
Advance
Key
Pressing this key advances the screen from right to left.
Contrast/Remaining Film
Indicator
Advance Key
Multi-Copy/Error Indicator
Multi-Copy/Stop Key
Copy Key
Contrast Key
2-Screen Copy Key