Panasonic UB-5325 - Manual (Page 22)

Computer Interfacing
22
■ Panaboard Operation Panel
It is possible to perform the same operations as with the electronic board control panel (page 9) from the following
Panaboard Operation buttons.
Note
• While the Panaboard Operation Panel is displayed, the Copy Key and 2-Screen Copy Key on the electronic
board control panel are used for scanning images into the computer.
Panel Name Description
Contrast/
Remaining Film
Indicator
This lamp indicator notifies the user when the time to
replace the thermal transfer film is approaching (estimated)
and of the contrast used during scanning or copying.
Indicator off:
Normal scanning or copying contrast
Indicator on: Darker than normal scanning or
copying contrast
Indicator flashing*: Almost time to replace the thermal
transfer film
(Note that only about 15 more sheets may
be copied when this indicator starts
flashing.)
Replacement film (UG-6001) is separately
available from the dealer where you purchased
your unit.
* The flashing indicator will go out after the power is turned off, or
the printer has been opened and closed. (When copying is per-
formed, this indicator will begin flashing again.)
Contrast Button
Each time this button is pressed, the unit will alternate
between normal and dark contrast modes (Normal/Dark).
2-Screen Scan
Button This button scans the front and back of the screen on a
single page.
Multi-Copy/
Error Indicator
This indicator displays the number of copies to be made.
The display changes each time the Multi-Copy/Stop Button
is pressed.
Example: 1 → 2 → ··· → 9 → 1 → ···
When an error occurs, a flashing symbol will appear in this display to
indicate the error status. (See page 27.)
Multi-Copy/Stop
Button
When making multiple copies, press this button until the
desired number of copies is displayed on the Multi-Copy/
Error Indicator. This button can also be pressed to stop
copying while executing multiple copies.
• The display changes as shown below each time the screen is copied.
After reaching 0, the display will reset to 1.
Example: 5 → 4 → 3 → 2 → 1 → 0 → 1
(Number is counted down.)
* If scanning, the setting 1 to 9 for the number of copies is
ignored.
Scan Button This button scans the screen.
Advance Button Clicking this button advances the screen from right to left.