Printronix LQH-HWTM - Manual (Page 21)

Modes of Operation
21
Table 3. Execute Form Mode Commands
Command Mnemonic Description Page #
Compressed Print DENSITY Defines the horizontal print density in characters per inch (cpi). 45
Dynamic
Alphanumeric Data AF n Executes the dynamic alphanumeric data provided after the
(cc) EXECUTE command. 62
Dynamic Bar Code
Data BF n Executes the dynamic bar code data provided after the (cc)
EXECUTE command. 63
Expanded Print EXPAND Expands fonts vertically and horizontally. 68
Font FONT Selects a specific typeface: bold, slant (italic) factor, and
symbol set. 69
Ignore Sequence
On/Off IGON
IGOFF Enables the IGP to ignore all characters after the Ignore
Sequence On command is sent until the Ignore Sequence Off
command is sent. 71
Incremental
Alphanumeric
Dynamic Data IAF n Executes the incremental dynamic alphanumeric data provided
after the (cc) EXECUTE command. 65
Incremental Bar
Code Dynamic Data IBF n Executes the incremental dynamic bar code data provided
after the (cc) EXECUTE command. 65
Line Spacing,
Vertical LPI Defines the lines per inch (lpi) printing format. 71
Multinational
Character Set ISET Selects one of the multinational or international character sets. Chap. 5
Normal Mode NORMAL Places the IGP in the Normal Mode, where it does not change
the data stream but awaits the SFCC followed by an IGP
command. 78
Reset RESET Deletes all forms and logos from the IGP memory. 82
Select Format
On/Off SFON
SFOFF Ignores all host-generated paper movement commands. See
note on page 20. 84
SFCC SFCC Changes the current Special Function Control Code (SFCC). 86