beautypg.com

Polycom Mitel Networks 3300 User Manual

Page 56

background image

SpectraLink Corporation

Configuration and Administration—NetLink e340/i640 Wireless Telephone

Mitel Networks 3300 and SX-200 ICP and 5220 IP Phone emulation

PN: 72-1084-02-G.doc

Page 56

Message Description

Action

Net Busy

xxxxxxxxxxxx

x…x = AP MAC address

Handset cannot obtain sufficient bandwidth

to support a call; displays MAC of failing AP.

Try the call again later.

No DHCP Server

Handset is unable to contact the DHCP

server.

Check that DNCP is operational and

connected to WLAN or use Static IP

configuration in the handset.

No ESSID

Attempted to run site survey application

without an ESSID set.

Let handset come completely up.

Statically configure an ESSID in the Admin

menu.

No Func Code

Handset software download files are

incorrect or corrupted

Reconfigure the handset to gain access to

the WLAN and download new code.

No Host IP

The handset is configured for “static IP” (as

opposed to “use DHCP”) and no valid host IP

address (the handset’s IP address) has been

entered.

Enter a valid IP address in the

configuration settings or change to “use

DHCP”.

No IP Address

Invalid IP

Check the IP address of the handset and

re-configure if required.

No Net Access

Cannot authenticate / associate with AP

Verify the AP configuration.

Verify that all the WEP settings in the

handset match those in the APs.

No Net Found

No APs

Handset cannot find any Access Points

This indicates any of the following:

No radio link

Verify that the AP is turned on.

No ESSID – Auto-learn not supported (or)

incorrect ESSID

Verify the ESSID of the wireless LAN and

enter or Autolearn it again if required.

AP does not support appropriate data rates

Check the AP configuration against

Configuration Note for AP.

Out of range

Try getting closer to an AP. Check to see if

other handsets are working within the

same range of an AP. If so, check the

ESSID of this handset.

Incorrect Security settings

Verify that all the Security settings in the

handset match those in the APs

No Net Found

xxxxxxxxxxxx yy

x…x = AP MAC address

yy = AP signal strength

Handset cannot find a suitable access point;

displays MAC and signal strength of “best”

non-suitable AP found.

Check AP and handset network settings

such as ESSID, Security, Reg domain and

Tx power.

Ensure APs are configured per

Configuration Note

.

Try Site Survey mode to determine more

specific cause.

No PBX IP Addr

The Handset could not locate the Mitel PBX.

If the handset is operating in static IP

mode, make sure that the PBX IP address

has been entered in the administrative

menus under RTC IP Addr. In DHCP mode,

ensure that the system administrator has

properly entered the DHCP option

parameters at the DHCP server.

This manual is related to the following products: