Polycom Mitel Networks 3300 - Manual (Page 55)

SpectraLink Corporation Configuration and Administration—NetLink e340/i640 Wireless Telephone
Mitel Networks 3300 and SX-200 ICP and 5220 IP Phone emulation
PN: 72-1084-02-G.doc Page 55
Message Description Action
Erasing Memory Handset has determined that a download
should occur and is erasing the current
software from memory.
None. When the progress bar fills the
display line the erase operation is
complete.
Do not turn the handset off during this
operation.
Far End TCP Close The handset has lost communication with the
PBX.
No action necessary. After about 20
seconds, the handset will re-initialize and
reconnect to either the same PBX or to
another PBX if it has been instructed to do
so or the first PBX fails to respond.
Files Too Big Handset software download files are
incorrect or corrupted
Download new software from the
SpectraLink site per Software
Maintenance .
Flash Config Error Handset internal configuration is corrupt. Perform "Restore Defaults" operation via
administrator menus [or reprogram with
Configuration Cradle]
Forced Redirect The PBX has told the handset to re-register
with another PBX.
No action necessary.
Get Button Defs The Handset is attempting to get definitions
from the PBX of how the user-programmable
keys are currently programmed.
No action necessary.
Initializing … The handset is performing power on
initialization
None. This is informational only.
Internal Err. # # The handset has detected a fault from which
it cannot recover.
Record the error code so it can be
reported.
Turn the handset off then on again.
If error persists, try registering a different
handset to this telephone port.
If error still persists, contact SpectraLink
Technical Support and report the error.
Invalid Redirect The PBX has told the handset to re-attempt
registration with another PBX. The reason
code in the redirect message is invalid.
No action necessary.
Multiple GW Res More than one NetLink SVP Server has
responded
Caused by two or more handsets sharing
the same IP address. Assign unique IP
addresses to each phone.
Multiple SVP Reg
yyy.yyy.yyy.yyy
y…y = SVP IP address
Handset received responses from multiple
SVP Servers; displays IP address of one
responding SVP Server
This can happen if the handset has been
re-configured to use a different SVP server
and then powered-up before the previous
server has had time to determine that the
handset is no longer connected to it. The
problem should go away after about 30
seconds.
Must Upgrade SW! Handset software is incompatible with
hardware.
Download new software from the
SpectraLink site per Software
Maintenance .