Polycom Mitel Networks 3300 - Manual (Page 31)

SpectraLink Corporation Configuration and Administration—NetLink e340/i640 Wireless Telephone
Mitel Networks 3300 and SX-200 ICP and 5220 IP Phone emulation
PN: 72-1084-02-G.doc Page 31
5. License Management
NetLink Wireless Telephones support a number of different IP protocol
integrations. All NetLink e340/h340/i640 Wireless Telephones are shipped from
SpectraLink with a generic software load that allows them to associate to a wireless
LAN and download their functional software from a TFTP server. The handsets
will not function properly without downloading appropriate software.
The following details the process to properly configure NetLink e340/h340/i640
Wireless Telephones and download software via over-the-air file transfer.
5.1 Requirements
• A wireless LAN must be properly configured and operational through the use of
802.11b wireless access points.
• A TFTP server must be available on the network in order to load the appropriate
software into the handsets.
• Finally, ensure that the Battery Pack on the handset is fully charged.
5.2 Configuration Process
1. Download the latest NetLink e340/h340/i640 Wireless Telephone IP software
from http://www.polycom.com/usa/en/support/voice/wi-fi/wi-fi.html .
For the SBC HIPCS solution, software is pre-loaded onto an SBC TFTP
server. It is not necessary to update the software from the SpectraLink
website.
2. Load the latest version of the MiNET code and place it on the TFTP server and
ensure the TFTP server is started. The five files that are needed must be named:
slnk_cfg.cfg
pd11g13.bin
pd11mtd.bin
pd11mtd3.bin
pi110001.bin
3. If statically assigning IP addresses, ensure that the Phone IP address, TFTP
server IP, Subnet Mask, and Default Gateway information are accurate in the
Admin menu. If using a DHCP server, ensure that appropriate options are set
for the TFTP server. See the NetLink Wireless Telephone Configuration section
for detailed configuration instructions.
4. Ensure the handset has properly configured ESSID and Reg Domain
Information within the Admin menu. If you are accepting broadcast ESSIDs at
your access points, the handset will automatically learn the ESSID information
when powering on. See NetLink Wireless Telephone Configuration section for
detailed configuration instructions.
5. Using the Admin menu on the handset, ensure the License Option menu option
is set to 014. This ensures the handset will check for the proper MiNET files