Polycom Mitel Networks 3300 User Manual
Page 20
SpectraLink Corporation
Configuration and Administration—NetLink e340/i640 Wireless Telephone
Mitel Networks 3300 and SX-200 ICP and 5220 IP Phone emulation
PN: 72-1084-02-G.doc
Page 20
Admin Menu Items
2
nd
Level
3
rd
Level
4
th
Level
5
th
Level
Transmit
Power
*Maximum
50 mW †
30 mW †
20
mW
15
mW
10
mW
5
mW
Diagnostics
Run Site Survey
Diagnostics Mode
Diagnostics On
*Diagnostics Off
Syslog
Mode
*Disabled
Errors
Events
Full
Restore Defaults
* default setting
† 50 mW and 30 mW only appear if Regulatory Domain is set to None or 01.
Phone Config
License Option
License Option lets you select the VoIP protocol that your site is licensed to
download and run. The MiNET protocol to use for the NetLink e340/h340 and
i640 Wireless Telephones requires License Option
014
. Any other protocol will
cause the handset to malfunction.
Clear PIN Number
The PIN number is saved in the handset’s local memory. If it is necessary to change
the PIN number assigned to this handset, clear the existing number through this
Admin menu option and power cycle the handset. The PBX will request a PIN
number when the handset is powered on, just as it does with the 5220 IP Phone.
Enter the PIN number and press the
Send
softkey. The new PIN number will be
sent to the PBX. If the new PIN is accepted by the PBX, it will tell the handset to
save the PIN in its local memory.
5220 Emulation
Disable 5220
is the default and should be used if configuring for the SX-200 ICP or
the 3300 ICP is using software version 5.1 or greater. With this revision, the Mitel
Networks system became capable of recognizing NetLink Wireless Telephones. If
the 3300 ICP software version in use is below 5.1, select
Enable 5220
to allow Mitel
Networks to recognize the NetLink Wireless Telephone as a 5220 IP Phone.
OAI On/Off
SpectraLink’s Open Application Interface (OAI) enables third-party computer
applications to display alphanumeric messages on the handset display and take input
from the handset keypad. Refer to the Open Application Interface (OAI) Specification
documentation for information about administering the OAI Gateway and the
services it can provide.
If you have an OAI Gateway installed in your system, OAI may be optionally
enabled in each handset. You may select whether the handset should attempt to
connect to the SpectraLink OAI Gateway by choosing either the Enable or Disable
options in this menu.