Philips G-CODE 7819901511 - Manual (Page 28)

27
Timer Recor
ding
• You may not be able to record a program from TV or
from another device connected to this recorder, if the
source material is copy-protected (e.g. set in ‘Copy-
Once’ or ‘Copy-Never’ modes)..
• You CANNOT record/copy a rented or purchased video/
disc from another device (video cassette recorder, DVD
player, DVD recorder, etc.) connected to this recorder.
• This DVD recorder adopts the DVD+VR recording
format, which enjoys a relatively greater compatibility.
However, it is still likely that recordings made with this
recorder may not be able to be played back on other
DVD recorders or DVD players.
..........................................................................................
Before you start...
• Refer to ‘Recording: Step by Step’ for the basic
procedures of recording on a disc.
Recording: Step by Step (p.24)
• Correctly set the system date and time of the DVD
recorder.
Introducing System Setup (p.12)
• Complete the channel scanning process for your TV.
Setting TV Channel (p.15)
• If you would like to use G-Code mode for your timer
program settimg, refer to
Setting up the G-Code System(p.18)
Introducing Timer Record Menu
Press TIMER to display the Timer Record menu.
If your model supports the G-Code system, you can
presson a highlighted program to switch between the
‘Date/Time Setting’ mode and the ‘G-Code Setting’ mode.
Date/Time Mode
Timer_01_01
Storage capacity available on the destination disc for a
particular recording mode.
Current system date.
Current system time.
The page you are viewing.
Error message bar.
Indicate function of canceling designated program
setting. Highlight this icon and press OK to clear
settings.
The TV channel(s) as recording source .
Recording frequency.
Recording date.
Recording time slot .
The status of preset timer program(s).
: Timer Program successfully activated.
: Timer Program not successfully activated.
Next Page: Press to switch to the next page.
Exit: Press to exit the Timer Record menu.
 The timer program list is automatically sorted by
system according to the start time of each program,
regardless of its recording mode, recording frequency,
or the order you enter the timer settings.
 You can set up a maximum of 16 programs for timer
recording, which will be displayed on two separate
pages. If the number of preset programs is less than
eight, only one page will be displayed, and the ‘Next
Page’ button will not be shown.
Timer Recording