Philips G-CODE 7819901511 - Manual (Page 19)

18
Started_Advanced_02_09
The channel selected will then be switched on or off.
3. To switch on or off other channels, repeat steps 1-2 to
complete the settings.
..........................................................................................
Fine-Tuning TV Channels
After you have performed the channel scanning, you may
like to fine-tune the TV channel signal manually. Follow
the steps listed below to complete the function.
1. Press  to select a channel from the list, then press
OK.
2. Press  to select ‘Fine Tune’, then press OK.
3. Press  or the number buttons (0-9), then press OK
to fine-tune the channel signal.
Started_Advanced_02_10
4. When completed, press  to select ‘Exit’ or
another option to continue, then press OK.
Setting the G-Code System
The G-Code system is a specially-designed
feature for recording TV programs. The system greatly
simplifies the timer recording process, as it does not
require users to enter program information, such as date,
channel number and start/end time, which are all contained
in G-Code programming numbers. You can complete the
timer recording setup simply by inputting the G-Code
number, which can be found in most newspapers, TV
listing magazines or online sources.
Setting up G-Code
System
As channel numbers may vary depending on where you
live, it is suggested that you build up a matching channel
list when you first set up the DVD recorder. This step will
help you to make use of the G-Code system for future
timer recording settings.
1. Press TV(MODE) or press SOURCE to set ‘TV’ as
the signal source.
2. Press EDIT to display the Channel Editor menu.
3. Press  to select a TV channel, then press OK.
4. Press  to select ‘GCN’, then press OK.
Started_Advanced_03_01
The dialogue box for entering GCN will appear.
5. Press the number buttons (0-9) to enter the GCN (guide
channel number), which is the channel number used by
the G-Code system, then press OK.
6. To set GCN for other channels, repeat steps 3-5.
7. When completed, press  to select ‘Exit’, then
press OK.