Philips G-CODE 7819901511 - Manual (Page 18)

17
Getting Started
3. Each time when you press OK, the item changes as
follows:
Started_Advanced_02_02
4. When completed, press  to select ‘Exit’ or
another option to continue, then press OK.
..........................................................................................
Inserting TV Channels
1. Press  to select a channel from the list, press OK.
2. Press  to select ‘Insert’, then press OK.
3. Press  or the number buttons (0-9) to enter
the channel number, then press OK.
Started_Advanced_02_04
3 5
Started_Advanced_02_02
The channel will be moved to the desired location.
4. When completed, press  to select ‘Exit’ or
another option to continue, then press OK.
 After you insert channel(s), numbers of other channels
will change accordingly.
Swapping TV Channels
1. Press  to select a channel from the list, then press
OK.
2. Press  to select ‘Swap’, then press OK.
Starteww wwwwwwwd_Advanced_02_06
9
3. Press  or the number buttons to enter the
channel number, then press OK.
Started_Advanced_02_07
The channel will be swapped to the designated location.
4. To swap other TV channels, repeat steps 1-3 to
complete the settings.
..........................................................................................
Renaming TV Channels
1. Press  to select a channel from the list, then press
OK.
2. Press  to select ‘Rename’, then press OK.
3. The ‘on-screen input keypad’ will be displayed. Follow
the instruction in ‘Using On-Screen Input Keypad’ to
enter characters.
You can enter up to 10 characters for a name.
On-Screen Input Keypad (p.23)
4. When completed, press  to select ‘Finish’,
then press OK.
..........................................................................................
Enabling/Disabling TV
Channels
You can temporarily remove unwanted channel(s) from
the list created from automatic scanning process or add the
previously disabled channel(s) back to the list.
1. Press  to select a TV channel which you would
like to switch on/off, then press OK.
2. Press  to select ‘Enable’ or ‘Disable’, then press
OK.