Panasonic PT VX400NTU - Manual (Page 33)

Powering ON/OFF
ENGLISH -
33
Basic Operation
Press the button on the control 1 )
panel or the button on the remote
control, and Power off? appears on the screen.
Press the button on the 2 )
control panel or the button on the
remote control again to turn off the projector. The
indicator starts to blink red, and the
cooling fans keep running. At this time, you can
unplug the AC power cord even if the fans are
still running.
When the projector has cooled down enough,
3 )
the indicator stops blinking and you
can turn on the projecto r.
Note
Do not put the projector in a case before the projector is z
cooled enough.
While the indicator is blinking, the lamp is z
being cooled down and the projector cannot be turned
on. Wait until the indicator stops blinking to
turn on the projector again.
The projector can be turned on after the z
indicator turns red. The waiting time to restart will be
shortened when the normal power-off processing for fan
cooling is completed, compared with the time the AC
power cord is immediately unplugged after the power-off.
J
Direct Power Off function
Even if you turn off the button
during projection or just after the lamp turns off, the
cooling fan will continue to rotate using internally
stored power. In cases where the
BY> switch is not easily accessible, such as during
ceiling mount, you can safely turn off the power by
using the power breaker switch. This function also
works if a power outage occurs or if the power cable
is accidentally disconnected from the outlet right after
turning the power off.
Note
When using the Direct power Off function, you can z
not restart the projector immediately after the power is
disconnected. The lamp remains high temperature and
needs to be cooled, so it sometimes takes longer time
than usual for the lamp to light up again.
While the cooling fan is operating, do not place the z
projector inside a box or bag.
Turning Off the Projector
Power off? disappears after 4 seconds.