Panasonic PT VX400NTU - Manual (Page 20)

About Your Projector
20
- ENGLISH
Preparation
(14) Button
Act as the On-Off switch for the Pointer.
( Æ page 37)
(15) Buttons
Scroll back and forth the pages on the screen
when giving a presentation. To use these buttons,
connect the projector and your computer with a
USB cable.
(16) Button
Mute the sound. ( Æ page 38)
(17) Buttons
Zoom in and out the images. (
Æ page 53)
(18) Button
Pauses the projected image and sound
tentatively. ( Æ page 39)
(19) Button
Temporarily turn off the image on the screen.
( Æ page 39)
(20) Button
Select a screen mode. ( Æ page 52)
(21) Button
Operate the P-timer function. ( Æ page 39)
(22) Button
Select a lamp mode. ( Æ page 39)
(23) ON/OFF switch
When using the remote control, set this switch to
“ON”. Set it to “OFF” for power saving when it is
not in use.
(24) Input Selection buttons:
1>, , , ,
, .
These buttons are used to select the input signal.
( Æ page 38)
(25) Button
Correct keystone distortion. ( Æ page 37)
Attention
Do not drop the remote control. z
Avoid contact with liquids. z
Do not attempt to modify or disassemble the remote z
control.
Note
The remote control can be used within a distance of z
about 5 m (16.4 ft) if pointed directly at the remote control
signal receiver. The remote control can control at angles
of up to ± 30 ° vertically and ± 30 ° horizontally, but the
effective control range may be reduced.
If there are any obstacles between the remote control z
and the remote control signal receiver, the remote control
may not operate correctly.
You can operate the projector by reflecting the remote z
control signal on the screen. The operating range may
differ due to the loss of light caused by the properties of
the screen.
When the remote control signal receiver is lit with a z
fluorescent light or other strong light source, the projector
may become inoperative. Set the projector as far from
the luminous source as possible.
(15)
(24)
(21)
(20)
(22)
(25)
(18)
(14)
(17)
(19)
(16)
(23)