Philips DV900VHS - Manual (Page 46)

46 MTS (Multi-Channel Television Sound) System
To record and play back programs broadcast in stereo, even if you have a single-speaker TV, just use one
of the connections shown, then follow the steps on pages 47-48.
STOP 12:00 AM
TV STEREO CH 02
STEREO
2ND AUD
SLP 1:23:45 HIFI
Your DVD/VCR can play recordings broadcast in Hi-Fi (high fidelity) stereo, which produces a crisp, clear
sound from two sources. Your DVD/VCR also can play tapes recorded in a second audio (usually, that
means your program is recorded in a second language). Of course, your DVD/VCR will play tapes record-
ed in monaural (single-source) sound as well.
Your DVD/VCR also will record in Hi-Fi stereo or in second audio, so when you play back that tape on
the DVD/VCR, it will be in stereo or second audio.
Read the directions on this page to familiarize yourself with your DVD/VCR’s stereo and second audio
setups. Then follow the directions on page 47 to record in stereo or second audio and the directions on
page 48 to play back tapes recorded in Hi-Fi stereo.
Understanding On-Screen Displays
When you receive a signal from a channel you’re watching, portions of the on-screen display shown below
will appear when you press the DISPLAY/STATUS/EXIT button on the remote control.
Specifically…
When a program broadcast in stereo is available, STEREO appears here.
When a program broadcast in second audio is available, 2ND AUD
appears here.
When a program is available both in stereo and second audio, both
STEREO and 2ND AUD appear here. Even though a program is avail-
able in stereo or second audio, you still must program the DVD/VCR to
receive or record the program. Follow the directions on page 47.
NOTE: Although a program may be broadcast in both stereo and second
audio, you cannot record in both stereo and second audio at the same time.
The indication 2ND AUD or TV
STEREO that appears on this side of
the status display tells you if your
DVD/VCR is programmed to receive a
second audio or stereo broadcast (it
cannot be programmed to receive
both at the same time). The indication 2ND AUD or STEREO
that appears on this side of the status
display tells you if the program you’re
watching is available in second audio
or stereo.
This indication is not available during
tape playback.
STOP 12:00 AM
TV STEREO CH 02
STEREO
2ND AUD
SLP 1:23:45 HIFI
Stereo Amplifier
or Receiver
Monitor
TV
Single
Speaker TV
Stereo
Speaker TV
OR
R
Monaural Sound
L
OR
Audio cables from
DVD/VCR AUDIO OUT
Jacks of DVD/VCR to
AUDIO IN Jacks of Stereo
Amplifier or Receiver
Video cable from DVD/VCR VIDEO OUT Jack of
DVD/VCR to VIDEO IN Jack of monitor TV
RF coaxial cable (supplied) from DVD/VCR’s
ANT-OUT (Antenna Out) jack to TV’s
ANTENNA IN Jack
VCR