Philips DV900VHS - Manual (Page 43)

RECORD
1 2 3
5 4 6
7 8 9
0
DVD/VCR
OUTPUT MEMORY
TIMER SET
DISPLAY
+10 SPEED
SETUP
TITLE MENU
MODE AUDIO ANGLE SUB TITLE
ENTER
SEARCH MODE
TIME SEARCH STATUS/EXIT
VCR/TV
VCR DVD
RETURN
CLEAR
CHANNEL
PLAY
STOP
PAUSE
SLOW
REW F.FWD
REPEAT
A B
POWER
SKIP
Time Search 43
Follow the steps below to program the DVD/VCR to search for-
ward or backward on a tape a specific length of time. There must
be a tape in the DVD/VCR.
● Before you begin, place the DVD/VCR in VCR mode. Press the
DVD/VCR OUTPUT button so that the green VCR light appears
on the front of the DVD/VCR. Press the VCR/TV button so that
the VCR/TV light appears on the front of the DVD/VCR.
1
Press the VCR button, then press the SEARCH
MODE/TIME SEARCH button.
2
Within 10 seconds, use the Number buttons to enter the
desired length of time you want to skip forward or back-
ward. For example, for 1 hour, 25 minutes, press Number but-
tons 1, 2, 5. Or, for five minutes, press Number buttons 0, 0, 5.
3
Within 10 seconds, press the F.FWD button or the
REW(ind) button. The DVD/VCR will skip over the specified
length of time, then begin playback.
• If you want to search for more than
59 minutes, you must enter the
length of time in hours and minutes.
For example, to search forward 70
minutes, press 1,1,0 at step 2.
• You can not do a Time Search while
recording.
• To remove the Time Search display,
press the SEARCH MODE/TIME
SEARCH button again.
• To cancel a Time Search that is in
progress, press the STOP button.
• If the end of the tape is reached
during a Time Search, the Time
Search will be cancelled. The
DVD/VCR may rewind the tape.
Details are on page 45.
Helpful Hints
TIME SEARCH
0:00
ENTER SEARCH TIME
3
2
1
VCR
1