Panasonic AG-AC160AEN - Manual (Page 44)

44
Using shooting settings (scene files)
Settings according to a variety of shooting
conditions are stored in the positions on the
dial ( to ).
When shooting, you can use the
dial to immediately read out required files.
• The following files are stored as factory
settings.
: [SCENE]
File suitable for normal shooting.
: [SCENE FLUO.]
File suitable for shooting under fluorescent
lights (indoor shooting).
: [SCENE SPARK]
File suitable for shooting with fuller variations
of resolution, coloring, and contrast.
: [SCENE B-STR]
File suitable for broadening the contrast of
dark areas (such as shooting sunsets).
: [SCENE CINE V]
File suitable for shooting movie-like scenes
where contrast is emphasized. (Even when
the scene file is changed, the recording
format is unchanged. It must be set with the
[REC FORMAT] item on the [RECORDING
SETUP] screen. See page 89.)
: [SCENE CINE D]
File suitable for shooting movie-like scenes
where dynamic range is emphasized. (Even
when the scene file is changed, the recording
format is unchanged. It must be set with the
[REC FORMAT] item on the [RECORDING
SETUP] screen. See page 89.)
Changing scene file settings
The setting value of a scene file can be changed.
Also, changed scene files can be stored at each
position of the dial ( to ).
Example: Change the name of the scene file
1
Turn the POWER/MODE switch of the
camera . (Page 30 of Vol.1)
2
Turn the dial to select a
scene file to change.
3
Select the setup menu [SCENE FILE] screen.
• Menu operation (Page 31 of Vol.1)
• Operations can be performed with buttons on
the remote control that correspond to those on
the camera. For details, see “Remote control”
(Page 24 of Vol.1).
4
Tilt the OPERATION lever in the < >< >
directions to select the [NAME EDIT] item.
5
Push the OPERATION lever (or tilt in the
< > direction) and tilt in the < > direction
to select [YES], then push the OPERATION
lever again.