Panasonic WJ-HD100 - Manual (Page 22)

22
● Password Setup
102 PASSWORD LOCK
A 5-digit password is entered to protect all settings, record-
ed pictures, and operating status, or settings only from
unauthorized access. While the LOCK indicator on the front
panel is on, the LCD displays the message "Now Key
Locked!" to warn unauthorized operators. If accessed in
this condition, the buzzer beeps.
OPERATE
TIMER HDD
ALARM
SUSPEND
DAYLIGHT
SAVINGS
FULL
LOCK
MEMORY CARD DISP
LCD
Turned on while the buttons are locked.
DISPLAY SELECT
LCD CONTRAST
SYSTEM SETUP
FWD/REW MODE SKIP&PLAY
PASSWORD LOCK
OFF
ALL
→
*****
OPERATION
→
*****
KEYLOCK BUZZER OFF
RESET PULSE HIGH
TIME ADJUSTING SLAVE
SET TIME
→
9:00
AUTO ERASING OFF
DISPLAY SELECT
LCD CONTRAST
DISPLAY SELECT
LCD CONTRAST
1. Move the cursor to PASSWORD LOCK with the up [▲]
or down [▼] button.
2. Select either ON or OFF with the JogDial.
The default is OFF.
ON: Buttons are password protected against erroneous
operation and tampering. When set to ON, the
recorder enters the button lock mode if neither a
button nor the JogDial is operated within a period of
five minutes.
OFF: No password protection is applied unless the but-
ton lock mode is enabled using the LCD button as
described in the right column of this page.
Note: Select OFF when you do not need the button lock
mode. When set to ON, the recorder enters the but-
ton lock mode if neither a button nor the JogDial is
operated within a period of five minutes.
3. Move the cursor to ALL or OPERATION with the up [▲]
or down [▼] button.
ALL: Both normal operations and setup operations are
allowed.
OPERATION: Normal operations only are allowed.
4. Press the JogDial.
The preset password appears. The default is “12345”
for both ALL and OPERATION.
5. Select a number with the JogDial, then press it.
The cursor moves one digit to the right.
6. Repeat step 5 above until all digits are entered.
7. Press the [SETUP/ESC] button to confirm the entered
password. Go back to step 3 if you have not yet set the
OPERATION password.
● Setting Buzzer ON/OFF
105 KEYLOCK BUZ
1. Move the cursor to KEYLOCK BUZZER with the up [▲]
or down [▼] button.
2. Rotate the JogDial to select ON or OFF. The default is
OFF.
ON: Buzzer beeps when unauthorized access takes
place.
OFF: Buzzer does not sound.
SYSTEM SETUP
FWD/REW MODE SKIP&PLAY
PASSWORD LOCK OFF
ALL
→
*****
OPERATION
→
*****
KEYLOCK BUZZER OFF
RESET PULSE HIGH
TIME ADJUSTING SLAVE
SET TIME
→
9:00
AUTO ERASING OFF
DISPLAY SELECT
LCD CONTRAST