Initializing, Initializing setup data, Initializing all contents & setup data – Panasonic WJ-HD100 User Manual
Page 18
18
■
Initializing
You can either initialize all disk contents including image
data and setup data, or setup data only.
●
Initializing All Contents & Setup Data
Warning!
The following are irrevocable procedures. We
strongly recommend that you copy important pictures
from the hard disk to CompactFlash cards before initial-
izing.
1. Open the SYSTEM INFORMATION window, then move
the cursor to DEFAULT.
2. Press the JogDial to move the cursor to SET.
3. Press the JogDial.
4. Select YES with the JogDial.
YES:
Initializing of setup data is enabled.
5. Press the JogDial.
SET DONE appears on the monitor after initializing.
6. Press the [SETUP/ESC] button.
The cursor moves to DEFAULT.
7. Hold down the [SETUP/ESC] button for 2 seconds to
quit the setup.
1. Press the [■ STOP] button to stop recording or play-
back.
2. Turn off the power.
3. Set MODE switches #1 through 4 on the rear panel as
follows:
#1:
ON
#2:
OFF
#3:
OFF
#4:
ON
4. Turn on the power.
The disk contents and setup data are initialized.
5. Turn off the power, and return the MODE switches to
the previous positions.
●
Initializing Setup Data
MODE
ON
ON
OFF
1 2 3 4 5 6
NOW FORMATTING HDD
SYSTEM INFORMATION
HDD HOUR METER 1000H
HDD CAPACITY . GB
DEFAULT
→
SET
→