Paradyne HOTWIREt 7984 - Manual (Page 9)

v 7984-A2-GB20-10 February 1999
About This Guide
Document Purpose and Intended Audience
This guide contains information needed to set up, configure, and operate the
Hotwire 7984 Multirate High-bit-rate Digital Subscriber Line (M/HDSL) Standalone
Termination Unit with DSX-1 interface, and is intended for installers and
operators.
Document Summary
Section Description
Chapter 1 About the 7984 Standalone Termination Unit. Describes the
7984 Termination Unit’s features and capabilities.
Chapter 2 Using the Asynchronous Terminal Interface. Provides
instructions for accessing the user interface and navigating
through the screens.
Chapter 3 Initial Startup and Configuration. Provides procedures for
setting up the user interface and configuration steps.
Chapter 4 Monitoring the Unit. Describes using the LEDs, status, and
network statistics to monitor the unit.
Chapter 5 Testing. Provides information about available tests and test
setup.
Chapter 6 Messages and Troubleshooting. Provides information on
SNMP traps, device messages, and troubleshooting.
Chapter 7 Security. Presents procedures for creating a login, setting
the effective access levels, and controlling SNMP access.
Chapter 8 IP Addressing. Provides information and examples
regarding IP addresses.