Snmp management capabilities, Management information base (mib) support, Snmp trap support – Paradyne HOTWIREt 7984 User Manual
Page 15
About the Hotwire 7984 Standalone Termination Unit
1-5
7984-A2-GB20-10
February 1999
SNMP Management Capabilities
The termination unit supports SNMP Version 1, and can be managed by any
industry-standard SNMP manager and accessed using SNMP by external SNMP
managers.
Management Information Base (MIB) Support
For a detailed description of supported MIBs, visit Paradyne’s web site at
http://www.paradyne.com. The following MIBs are supported:
H
MIB II (RFC 1213 and RFC 1573) – Defines the general objects for use with
a network management protocol in TCP/IP internets and provides general
information about the unit. MIB II is backward-compatible with MIB I.
H
DS1 MIB (RFC 1406) – Reports the performance status of the DSX-1
interface and supports the features found on the DSX-1 Performance
Statistics screen.
H
RS-232-Like MIB (RFC 1659) – Defines objects for managing RS-232-type
interfaces (e.g., V.35, RS-422, RS-423, etc.) and supports the synchronous
data port on the DSU.
H
Enterprise MIB – Supports configuration, status, statistics, and tests.
SNMP Trap Support
The 7984 Standalone Termination Unit supports traps as defined in RFC 1215.
Figure 1-4 illustrates a typical M/HDSL SNMP configuration. Refer to Chapter 8,
Standards Compliance for SNMP Traps
99-16114a-01
DSX-1
8600
DSLAM
Network
7984
AC
INPUT
AC
48VDC CLASS 2 OR
LIMITED PWR SOURCE
RTN
48V
A
A
B
B
T5A
2
4
6
A
B
.
.
.
3
.
1
2
POSITION
STACK
ALM
A
IN
B
DC FUSES
T4A, MIN. 48V
5
DC PWR
FAN
OUT
SERIAL
MCC
1
3
1
2
3
SYSTEM
OK
Alr
m
Test
TX
RX
Col
1
2
3
4
ETHERNET
DSL POR
T
RADSL
8546
250V
SYSTEM
OK
Alr
m
Test
1
2
3
4
G.703 ALRM
DSL POR
T
LINK-UP
SDSL
8715
1
2
3
4
SYSTEM
OK
Alr
m
Test
1
2
3
4
G.703 ALRM
DSL POR
T
LINK-UP
SDSL
8715
1
2
3
4
Router
SNMP NMS
8784
Ethernet
Interface
DSL
EOC
Data
Operation, Maintenance
and Provisioning Center
Ethernet
LAN
Figure 1-4.
HDSL SNMP Configuration