Resetting the system, 1 switch the receiver into standby, 4 press enter to confirm – Pioneer VSX-919AH-K User Manual
Page 72: Default system settings, Password settings in, Resetting the, Using other functions 08
Using other functions
08
72
En
Resetting the system
Use this procedure to reset all the receiver’s
settings to the factory default. Use the front panel
controls to do this. Set
MULTI-ZONE to OFF.
• Disconnect the iPod and USB memory
device from the receiver beforehand.
1
Switch the receiver into standby.
2
While holding down ENTER on the front
panel, press
STANDBY/ON.
The display shows
RESET
NO .
3
Select ‘RESET’ using PRESET +/–, then
press ENTER on the front panel.
The display shows
RESET? OK.
4
Press ENTER to confirm.
OK appears in the display to indicate that the receiver
has been reset to the factory default settings.
• Note that all settings will be saved, even if
the receiver is unplugged.
Default system settings
Setting
Default
Digital Video Conversion
ON
SPEAKERS
A
Surround Back System
Normal
Speaker System Front
SMALL
Center
SMALL
Surr
SMALL
SB
SMALLx2
SW
YES
Crossover
80 Hz
X-Curve
OFF
DIMMER
brightest
Inputs
See
Input function default and possible settings on
MULTI-ZONE
Zone 2 Volume Level
Variable
Zone 2 Volume
–60 dB
HDMI
HDMI Audio
Amp
KURO LINK
ON
DSP
Surround back channel
Processing
ON
Phase Control
ON
Sound Retriever
iPod/USB
function
ON
Other functions
OFF
Sound Delay
0.0 frame
Dual Mono
CH1
DRC
AUTO
SACD Gain
0 dB
LFE Attenuate
0 dB
Auto delay
OFF
UP Mix
ON
Digital Safety
OFF
Effect Level
ExtendedStereo 90
Other modes
50
2 PL II Music
Options
Center Width
3
Dimension
0
Panorama
OFF
Neo:6 Options
Center Image
Neo:6 MUSIC: 3
Neo:6 CINEMA: 10
All Inputs
Listening Mode
(2 ch)
AUTO
SURROUND
Listening Mode
(x ch)
AUTO
SURROUND
Listening Mode
(HP)
STEREO
See also
Setting the Audio options on page 64 for
other default DSP settings.
MCACC
MCACC Position Memory
M1: MEMORY 1
Channel Level (M1 to M6)
0.0 dB
Speaker Distance (M1 to M6)
10’00”
Standing Wave
(M1 to M6)
ATT of all
channels/filters
0.0 dB
SWch Wide
Trim
0.0 dB
EQ Data (M1 to
M6)
All channels/
bands
0.0 dB
EQ Wide Trim
0.0 dB
Setting
Default
VSX-1019_KU.book Page 72 Thursday, January 8, 2009 12:01 PM