Pioneer VSX-919AH-K - Manual (Page 64)

Using other functions 08
64
En
Chapter 8:
Using other functions
Setting the Audio options
There are a number of additional sound
settings you can make using the
AUDIO
PARAMETER menu. The defaults, if not stated,
are listed in bold.
Important
• Note that if a setting doesn’t appear in the
AUDIO PARAMETER menu, it is
unavailable due to the current source,
settings and status of the receiver.
1 Press , then press AUDIO
PARAMETER.
2 Use
/ to select the setting you want to
adjust.
Depending on the current status/mode of the
receiver, certain options may not be able to be
selected. Check the table below for notes on
this.
3 Use / to set it as necessary.
See the table below for the options available for
each setting.
4 Press RETURN to confirm and exit the
menu.
RECEIVER
Setting What it does Option(s)
MCACC
(MCACC preset) Selects your favorite MCACC preset memory when multiple preset
memories are saved. When a MCACC preset memory has been
renamed, the given name is displayed. M1. MEMORY 1 to
M6. MEMORY 6
Default:
M1. MEMORY 1
EQ
(Acoustic
Calibration EQ) Switches on/off the effects of EQ Pro. ON
OFF a
S-WAVE
(Standing Wave) Switches on/off the effects of Standing Wave Control. ON
OFF
DELAY
(Sound Delay) Some monitors have a slight delay when showing video, so the
soundtrack will be slightly out of sync with the picture. By adding
a bit of delay, you can adjust the sound to match the presentation
of the video. 0.0 to 10.0 (frames)
1 second = 30
frames (NTSC)
Default: 0.0
MIDNIGHT Allows you to hear effective surround sound of movies at low
volumes. MIDNIGHT/
LOUDNESS OFF
MIDNIGHT ON
LOUDNESS Used to get good bass and treble from music sources at low
volumes.
LOUDNESS ON
TONE b
(Tone Control)
Applies the treble and bass tone controls to a source, or bypasses
them completely. BYPASS
ON
VSX-1019_KU.book Page 64 Thursday, January 8, 2009 12:01 PM