Pioneer VSX-919AH-K - Manual (Page 111)

Additional information 12
111
En
Configuration B
Connect your HDMI-equipped component
directly to the display using an HDMI cable.
Then use the most convenient connection
(digital is recommended) for sending audio to
the receiver. See the operating instructions for
more on audio connections. Set the display
volume to minimum when using this
configuration.
Note
• If your display only has one HDMI terminal,
you can only receive HDMI video from the
connected component.
• Depending on the component, audio
output may be limited to the number of
channels available from the connected
display unit (for example audio output is
reduced to 2 channels for a monitor with
stereo audio limitations).
• If you want to switch the input function,
you’ll have to switch functions on both the
receiver and your display unit.
• Since the sound is muted on the display
when using the HDMI connection, you
must adjust the volume on the display
every time you switch input functions.
USB interface
Symptoms Causes Remedies
The folders/files stored on
a USB memory device are
not displayed. The folders/files are currently stored
in a region other than the FAT (File
Allocation Table) region. Store the folders/files in the FAT region.
The number of levels in a folder is
more than 8. Limit the maximum number of levels in a
folder to 8 (page 45).
There are more than 30 000 folders/
files stored in a USB memory device. Limit the maximum number of folders/files
stored in a USB memory device to 30 000
(page 45).
The audio files are copyrighted. Copyrighted audio files stored on a USB
memory device cannot be played back
(page 45).
A USB memory device is
not recognized. The USB memory device does not
support the mass storage class
specifications. Try using a USB memory device compatible
with the mass storage class specifications.
Note that there are cases where even the
audio files stored on a USB memory device
compatible with the mass storage class
specifications are not played back on this
receiver (page 45).
Connect the USB memory device and
switch on this receiver (page 35).
A USB hub is currently being used. This receiver does not support a USB hub
(page 45).
This receiver recognizes the USB
memory device as a fraud. Switch off and on again this receiver.
VSX-1019_KU.book Page 111 Thursday, January 8, 2009 12:01 PM