Planet Technology WGSD-1020 - Manual (Page 10)

- 6 -
Figure 3. End node or Hub or Switch connection
Notice:
Cable distance for Switch
The cable distance between Ethernet Switch and hub/PC should not exceed 100 meter for
UTP/STP cable.
Make sure the wiring is correct
It can be used Category 3/4/5 cable in 10 Mbps operation. To reliably operate your network at
100Mbps and 1000Mbps, you must use an Unshielded Twisted-Pair (UTP) Category 5 cable, or
better Data Grade cabling. While a Category 3 or 4 cable may initially seem to work, it will soon
cause data loss.
2.3.3 Connecting to Network Backbone or Server
Connect to the Gigabit Ethernet ports with Category 5 copper cable for uplinking to a network
backbone or network server. These ports operate at 1000Mbps in full-duplex mode. A valid con-
nection is indicated when the Link LED is light.
Figure 4: Network Backbone or Server connection