Lenovo THINKCENTRE 8177 User Manual
Page 138
5.
For
all
drives
except
the
hard
disk
drive,
push
in
on
the
metal
tab
that
secures
the
drive
being
removed.
The
hard
disk
drive
tray
pivots
out
toward
the
front
of
the
computer
for
removal
of
the
hard
disk
drive.
See
the
following
illustrations.
For
the
hard
disk
drive,
see
the
illustration
below.
6.
Slide
the
drive
out
the
front
of
the
computer.
7.
Make
sure
the
drive
that
you
are
installing
is
set
correctly
as
either
a
master
or
a
slave
device.
Jumper
the
new
drive
the
same
as
the
drive
being
replaced.
Note:
If
you
are
installing
a
serial
ATA
drive,
no
master/slave
jumpering
is
necessary.
Refer
to
the
documentation
that
comes
with
your
drive
for
master/slave
jumper
information.
8.
Slide
the
drive
into
the
appropriate
bay.
9.
Reconnect
the
signal
and
power
cables
to
the
new
drive.
132
Hardware
Maintenance
Manual