Landmark Lighting D20R2-06/99 - Manual (Page 83)

JUMP Command Use the JUMP command to access the primary applid of a
Landmark product. You identified primary applids in Step 7 and
defined them in Step 8 of “Setting Up Landmark Product
Communication,” earlier in this chapter.
The syntax of the JUMP command is:
JUMP=code
where “code” is one of the following product identifiers.
Product Identifier
TMON for CICS TMONCICS
TMON for DB2 TMONDB2
TMON for DBCTL TMONDBC
TMON for MQSeries TMONMQ
TMON for MVS TMONMVS
REMOTE
Command Use the REMOTE command to access a specific applid of a
Landmark product. The syntax of the REMOTE command is:
REMOTE=applid
where “applid” is the applid of the product you want to access.
TMON for CICS/ESA example For example, if you want to access TMON for CICS/ESA applid
TCECHI, enter REMOTE=TCECHI.
Usage Notes A product accessed explicitly operates in exactly the same manner
as if you log onto it directly. The only difference is that explicit
access automatically logs you onto the product and skips the
product logon screen. You can perform all the product functions
on the explicitly accessed product that your user ID can perform
when you log onto the product directly. Any security limitations
set up for your user ID when you access the product directly are
active when you access the product explicitly. If your user ID is not
authorized to use the explicitly accessed product, the product
session’s logon screen is displayed. You then can select an
alternate user ID and password to complete explicit pass-through.
You may receive error messages from a Landmark product you are
trying to access explicitly. Usually this happens when an error
occurs during the access attempt. For help with these messages,
refer to the messages and codes manual for the appropriate
product.
When you log off of a product you accessed explicitly from one of
the Landmark PerformanceWorks MVS products, you return to the
same Landmark product. For example, when you log off of a
Chapter 3: Landmark Product Communication Using Explicit Pass-Through
The Monitor for MVS 2.0 3-11
System Administrator’s Guide