Configuring lan interface, Configuring lan interface in bridging mode, Configuring lan interface -7 – Lucent Technologies CELLPIPE 7820-0766-004 User Manual
Page 33: Configuring lan interface in bridging mode -7
Configuring a 20 Series CellPipe
Configuring LAN interface
CellPipe™ 20 Series User’s Guide
4-7
AS0_Dn_Latency_Actual
LS0_Up_Bytes_Actual 0
LS0_Up_Latency_Actual
Fast_R_Up_Actual 0
Interleave_S_Up_Actual
0
Interleave_D_Up_Actual 0
Interleave_R_Up_Actual 0
Fast_R_Dn_Actual 0
Interleave_S_Dn_Actual 0
Interleave_D_Dn_Actual 0
Interleave_R_Dn_Actual 0
Select the
stnl
command to configure the local ADSL coding type.
>adsl> stnl -
Select the
trellis
command to enable or disable Trellis encoding.
>adsl> trellis
Select the
tx_pwr
command to configure the transmitted power attentuation for a
range between 0 dB and 12 dB.
>adsl> tx_pwr <0> .. <12>
Select the
tx_bin
command to allow the user to limit bins used for special
configuration in the transmitted signal.
> adsl> tx_bin -
Configuring LAN interface
This section provides menus for configuring the LAN interface in both bridging and
routing mode.
Configuring LAN interface in bridging mode
The following is a list of the menus available under the
lan
command in bridging
mode: