Chip test four (ctest4), Chip test four, Ctest4) – LSI 53C810A User Manual
Page 108

5-34
Operating Registers
when an interrupt occurs. These bits are unstable while
data is being transferred between the two cores; once the
chip has stopped transferring data, these bits are stable.
The
register counts the number of
bytes transferred between the DMA core and the SCSI
core. The
register counts the
number of bytes transferred across the host bus. The
difference between these two counters represents the
number of bytes remaining in the DMA FIFO.
The following steps determine how many bytes are left in
the DMA FIFO when an error occurs, regardless of the
transfer direction:
1. Subtract the seven least significant bits of the
register from the 7-bit value of
the
register.
2. AND the result with 0x7F for a byte count between
zero and 64.
Note:
To calculate the total number of bytes in both the DMA
FIFO and SCSI logic, see
Section 2.5.1.1, “Data Paths,”
in
Chapter 2, “Functional Description.”
Register: 0x21 (0xA1)
Chip Test Four (CTEST4)
Read/Write
BDIS
Burst Disable
7
When set, this bit causes the LSI53C810A to perform
back-to-back cycles for all transfers. When this bit is
cleared, back-to-back transfers for opcode fetches and
burst transfers for data moves are performed. The
handling of opcode fetches is dependent on the setting of
the Burst Opcode Fetch bit in the
register.
7
6
5
4
3
2
0
BDIS
ZMOD
ZSD
SRTM
MPEE
FBL[2:0]
0
0
0
0
0
0
0
0