Lowrance electronic 5300c - Manual (Page 151)

143
To Reset Calibration:
1. Press
MENU
|
MENU
, select
NMEA 2000
and press
ENT
.
2. Highlight
F
UEL
M
ANAGEMENT
and press
ENT
.
3. Highlight
E
NGINE
S
ELECT
and press
ENT
. The Engine Select menu will
appear with up to four options: All Engines, Port, Center and Star-
board. Selecting All Engines will reset calibration for all engines back
to factory defaults.
4. Select All Engines or the engine connected to the desired device and
press
ENT
.
5. Highlight
R
ESET
C
ALIBRATION
and press
ENT
. The following message
will appear: Are you sure you wish to Reset Calibration?
6. Highlight
Y
ES
and press
ENT
. Press
EXIT
repeatedly to get back to the
main display.
EP-15 Fluid Level Calibration
The default calibration for the EP-15 Fluid Level is just as accurate as
standard fluid level gauges. If, however, the tank has an irregular
shape or greater accuracy is needed, calibration is recommended. There
are three calibration options: 2-Point, 3-Point and 5-Point.
2-Point Calibration
A 2-point calibration is best suited for rectangular or square-shaped
tanks, where the capacity of the top half of the tank matches the capac-
ity in the lower half of the tank. In a two-point calibration, you will set
two points, one each for empty and full levels. You can begin calibra-
tion at either of the two points, but we recommend starting with an
empty tank. You will fill the tank to complete calibration.
1. Press
MENU| MENU
, use ↓ ↑ to select
NMEA 2000
and press
ENT
.
2. Highlight
B
US
S
ETUP
and press
ENT
, which will open the Bus Configu-
ration menu. A list of network devices will be at the top of the page.
3. Select the EP-15 Fluid Level and press
ENT
.
4. Press ↓ to select
C
ALIBRATE
and press
ENT
. The Device Calibration
menu will appear. Instructions on Calibration will be listed at the top
of the menu.
5. Highlight
N
UM
P
TS
, press
ENT
and select
2.
Press
ENT
.
6.
Select F
LUID
L
EVEL
, press ENT, then select E
MPTY
L
EVEL
and
press
ENT.
7. Make sure the fuel tank is empty, highlight
C
ALIBRATE
and press
ENT
.
The following message will appear: Empty Level Calibration Com-
pleted.
Press ENT.
8.
Fill up your tank, highlight
F
LUID
L
EVEL
and press
ENT.
9.
Select
F
ULL
L
EVEL
and press
ENT.
Highlight
C
ALIBRATE
and press
ENT.
www.Busse-Yachtshop.de email: [email protected]