Lowrance electronic 5300c - Manual (Page 140)

132
2. Highlight
F
UEL
M
ANAGEMENT
and press
ENT
. The Fuel Management
menu will appear.
3. Highlight to
E
NGINE
S
ELECT
and press
ENT
. Select the desired engine —
the engine attached to the desired fuel flow — and press
ENT
.
4. Highlight
R
ESET
C
ALIBRATION
and press
ENT
. The following confirma-
tion message will appear: Are you sure you wish to Reset Calibration?
Select
Y
ES
and press
ENT
. Calibration settings for the selected fuel have
been returned to factory defaults.
To Reset Trip:
The Reset Trip function allows you to reset to zero the running total of
fuel used on a particular trip.
1. Press
MENU
|
MENU
, select
NMEA 2000
and press
ENT
.
2. Highlight
F
UEL
M
ANAGEMENT
and press
ENT
. The Fuel Management
menu will appear.
3. Select
R
ESET
T
RIP
and press
ENT
. The following confirmation message
will appear: Are you sure you wish to Reset Trip? Highlight
Y
ES
and
press
ENT
. The Trip Fuel Used figure has been reset to zero.
To Reset Seasonal:
Your unit can track fuel usage not only for trips, but also for entire sea-
sons. The reset seasonal command allows you to reset to zero the run-
ning total of fuel used during a season.
1. 1. Press
MENU
|
MENU
, select
NMEA 2000
and press
ENT
.
2. Highlight
F
UEL
M
ANAGEMENT
and press
ENT
. The Fuel Management
menu will appear.
3. Select
R
ESET
S
EASONAL
and press
ENT
. The following confirmation mes-
sage will appear: Are you sure you wish to Reset Seasonal?
Highlight
Y
ES
and press
ENT
. The Seasonal Fuel Used figure has been
reset to zero.
NMEA 2000 Alarms
The NMEA 2000 Alarms menu allows you to set Full and Empty fuel
alarms for the EP-10 Fuel Flow, EP-15 Fluid Level, EP-50 Storage De-
vice and the Suzuki Engine Interface. The alarms may be set to a per-
centage (0-100%) of tank capacity.
The second tab at the top of the NMEA 2000 Alarms page is the Alarm
Status Tab. When an alarm has been set for a device, the alarm and its
current status will be shown on the Alarm Status window. To view the
Alarm Status window, highlight the Alarm Status tab and press
ENT
.
To set NMEA 2000 Alarm:
1. Press
MENU
|
MENU
, select
NMEA 2000
and press
ENT
.
2. Highlight
NMEA 2000 A
LARMS
and press
ENT
.
www.Busse-Yachtshop.de email: [email protected]