Lowrance electronic 5300c - Manual (Page 143)

135
If you want to use your unit in a network including one of these digital
gauges, you may need to consult customer service.
You should never need this command if you are connecting your unit to
a network with similar display units and/or a series of electronic
probes.
Restore Defaults
The Restore Defaults command allows you to reset an individual EP-35
Temp Sensor's settings to factory defaults. If, for example, you execute
the Restore Defaults command from your Water Temp's Advanced Op-
tions menu, only the settings for the Water Temp will be reset to fac-
tory defaults. Other temps on the network will not be affected.
To restore default settings
:
1. Press
MENU| MENU
, use ↑ ↓ to select
NMEA 2000
and press
ENT
. The
NMEA 2000 menu will appear with five options: Bus Setup, Fuel Man-
agement, NMEA 2000 Alarms, Waypoint Sharing and Backlight Syn-
chronization.
2. Highlight
B
US
S
ETUP
and press
ENT
, which will open the Bus Configu-
ration menu. A list of network devices will be at the top of the page.
3. Select the desired temp sensor and press
ENT
. The Device Configura-
tion menu will appear.
4. Highlight
A
DVANCED
O
PTIONS
and press
ENT
.
5. Select
R
ESTORE
D
EFAULTS
and press
ENT
. The following message will
appear: Are you sure you wish to change this device's configuration?
6. Highlight
Y
ES
and press
ENT
. Press
EXIT
repeatedly to get back to the
main display.
EP-10 Fuel Flow Configuration
To input Device Name:
1. Press
MENU| MENU
, use ↑ ↓ to select
NMEA 2000
and press
ENT
. The
NMEA 2000 menu will appear with five options: Bus Setup, Fuel Man-
agement, NMEA 2000 Alarms, Waypoint Sharing and Backlight Syn-
chronization.
2. Highlight
B
US
S
ETUP
and press
ENT
, which will open the Bus Configu-
ration menu. A list of network devices will be at the top of the page.
3. Select the fuel flow you want to rename and press
ENT
. The Device
Configuration menu will appear with the Device Name dialog box high-
lighted.
4. Press
ENTER
and use ↑ ↓, ← → to input the desired name for the fuel
flow. Press
ENT
. Press
EXIT
repeatedly to get back to the main display.
www.Busse-Yachtshop.de email: [email protected]