Fuel management menu – Lowrance electronic 5300c User Manual

Page 138

130

NOTE:

If, as in the graphic above, you do not have a Suzuki Engine Inter-

face, EP-15 Fluid Level or EP-10 Fuel Flow on the network, the

Engine & Configuration menu, Tank Select menu, Tank Size dialog

and Set Configuration button will not be displayed on the Bus Con-

figuration menu.

Fuel Management Menu

The Fuel Management menu gives you access to the following options:

Tank Location, Fuel Added, Add Fuel, Fill Tank, Engine Select, Reset

Calibration, Reset Trip and Reset Seasonal. Those options allow you to

configure, calibrate, reset calibration, reset trip fuel and reset seasonal

fuel for select NMEA 2000 devices. We will cover configuration and cali-

bration procedures later in this section.

Fuel Management highlighted on the NMEA 2000 menu (left).

Fuel Management menu (right).

Tank Location

If you chose an engine-tank configuration with more than one tank, you

will be able to switch the tank location (configuration) in the Tank Lo-

cation menu. When fuel is added to a tank, you will select the correct

tank from the Tank Location menu, then input the amount of fuel

added in the Fuel Added dialog box.

Fuel Added

Used in tandem with the Add Fuel command, the Fuel Added dialog

box allows you to input the amount of fuel added to the tank, when an

amount of fuel is added that does not fill up the tank.

Add Fuel

After entering the amount of fuel added to a tank in the Fuel Added

dialog, the Add Fuel command finalizes the entry of the data. Like the

Fuel Added dialog, the Add Fuel command will only be used when an

amount of fuel is added that does not fill up the tank.