Lowrance electronic 5300c - Manual (Page 141)

133
3. Highlight
F
LUID
L
EVEL
D
EVICE
and press
ENT
. Use ↑ ↓ to select the de-
vice you want to set an alarm for and press
ENT
.
4. Highlight the
E
NABLED
box next to the desired alarm (Full Alarm or
Empty Alarm) and press
ENT
to turn on the alarm.
5. To set the alarm percentage, press → to highlight
P
ERCENT
and press
ENT
.
6. Use ↑ ↓, ← → to input the desired percentage and press
ENT
. Repeat
Steps 3-4 to set the other alarm.
7. Highlight
S
ET
C
ONFIGURATION
and press
ENT
to finalize alarm settings.
Press
EXIT
repeatedly to get back to the main display.
NOTE:
To turn off (uncheck) an alarm, highlight its
E
NABLED BOX
and press
ENTER
.
Waypoint Sharing
Waypoint Sharing allows you to share a waypoint from one display unit
with display units across the network.
To turn on/off Waypoint Sharing:
1. Press
MENU
|
MENU
, select
NMEA 2000
and press
ENT
.
2. Highlight
W
AYPOINT
S
HARING
and press
ENT
which will turn on/off way-
point sharing.
3. Press
EXIT
repeatedly to get return to the main display.
Backlight Synchronization
The Backlight Synchronization command will keep all display unit
backlight levels consistent across the NMEA 2000 network. So, if you
set the backlight level to 75% on one display unit, all other units on the
network will automatically switch to the same setting.
To turn on/off Backlight Synchronization:
1. Press
MENU
|
MENU
, select
NMEA 2000
and press
ENT
.
2. Highlight
B
ACKLIGHT
S
YNCHRONIZATION
and press
ENT
, which will turn
on/off Backlight Synchronization.
3. Press
EXIT
repeatedly to get back to the main display.
Configuring EP Sensors
All configurable devices are configured through their Device Configura-
tion menus, which may be accessed through the network devices list on
the Bus Configuration menu.
www.Busse-Yachtshop.de email: [email protected]