Lowrance electronic 5300c - Manual (Page 133)

125
Section 7:
NMEA 2000 Device Configuration
NMEA 2000 Menu
The NMEA 2000 menu on your display unit's main menu allows you to
configure, calibrate and monitor devices on a NMEA 2000 network. The
NMEA 2000 menu provides access to the Bus Setup, Fuel Management
and NMEA 2000 Alarms. You also can turn on/off Waypoint Sharing
and Backlight Synchronization from the NMEA 2000 menu.
NOTE:
Your internal GPS receiver is a non-network device, so data from
the receiver CAN NOT be transmitted across a NMEA 2000 net-
work.
Internal GPS Receiver
GPS data from your internal GPS receiver can not be transmitted across
the network to other network devices. The only way to transmit GPS data
across the network is to add a LGC-2000 or LGC-3000 module to the
LowranceNET.
LGC-2000 highlighted on Buss Setup menu (left). LGC-2000 Device
Configuration menu with the Set Active checkbox selected (center).
LGC-2000 is now listed as Active on the Buss Setup menu (right).
To switch from internal GPS to LGC module
Press
MENU
, select
NMEA 2000
and press
ENT
. Choose
B
USS
S
ETUP
and
press
ENT
.
1. From the Buss Configuration list, select the LGC module and press
ENT
.
2. Press ↓ to Set Active and press
ENT
. The LGC module is now the ac-
tive antenna for your unit. The Internal GPS antenna was automati-
cally disabled when the LGC module was set to active.
www.Busse-Yachtshop.de email: [email protected]