Lowrance electronic 5300c - Manual (Page 148)

140
4. Press
ENT
and use ↑ ↓, ← → to input a name for the interface. Press
ENT
. Press
EXIT
repeatedly to return to the main display.
To select a Location:
1. Press
MENU| MENU
, use ↑ ↓ to select
NMEA 2000
and press
ENT
. The
NMEA 2000 menu will appear with five options: Bus Setup, Fuel Man-
agement, NMEA 2000 Alarms, Waypoint Sharing and Backlight Syn-
chronization.
2. Highlight
B
US
S
ETUP
and press
ENT
, which will open the Bus Configu-
ration menu. A list of network devices will be at the top of the page.
3. Select the desired engine interface and press
ENT
. The Device Con-
figuration menu will appear.
4. Highlight
L
OCATION
and press
ENT
, which will open the Location menu
with the following options: Port, Center, Starboard and Unknown.
5. Select the desired location and press
ENT
. The following confirmation
message will appear: Are you sure you wish to change this device's con-
figuration?
6. Press
ENT
. Press
EXIT
repeatedly to get back to the main display.
To select Engine Type:
1. Press
MENU| MENU
, use ↑ ↓ to select
NMEA 2000
and press
ENT
. The
NMEA 2000 menu will appear with five options: Bus Setup, Fuel Man-
agement, NMEA 2000 Alarms, Waypoint Sharing and Backlight Syn-
chronization.
2. Highlight
B
US
S
ETUP
and press
ENT
, which will open the Bus Configu-
ration menu. A list of network devices will be at the top of the page.
3. Use
↑ ↓ to select the desired engine interface and press
ENT
. The De-
vice Configuration menu will appear.
4. Highlight
E
NGINE
T
YPE
and press
ENT
, which will open the Engine
Type menu with the following options: DF40, DF50, DF60, DF70,
DF90/115, DF140, DF150, DF175, DF200/225, DF250 and DF300.
5. Select your engine type and press
ENT
. The following message will
appear: Are you sure you wish to change this device's configuration?
6. Highlight
Y
ES
and press
ENT
. Press
EXIT
repeatedly to get back to the
main display.
Advanced Options menu
The Engine Interface Advanced Options menu contains three catego-
ries: Instance, Restore Defaults and Reset Trim Calibration.
Instance
The Instance command is intended for use only by experienced NMEA
2000 network technicians. Instance allows network technicians to re-
solve certain electronic probe conflicts. This is most likely to occur if the
www.Busse-Yachtshop.de email: [email protected]