Lexmark 4I3 - Manual (Page 315)

S
serial cable, attaching a 2-23
serial number 3-2
settings, printer 3-16
setup, printer
check out ribbon cartridge
installation 1-9
F1 (Continuous Forms Device)
check out F1 forms device
installation 1-23
install the 1-21
load forms in the F1 forms
device 1-26
prepare to load F1
forms 1-24
print verification test for the F1
forms device 1-33
F2 (Dual Purpose Forms Device)
check out F2 forms device
installation 1-58
install the 1-55
load forms in the F2 forms
device 1-60
prepare to load F2
forms 1-59
print verification test for the F2
forms device 1-66
F3 (Document Insertion Device)
check out F3 forms device
installation 1-90
install the 1-88
load forms in the F3 forms
device 1-94
prepare to load F3
forms 1-93
print verification test for the F3
forms device 1-98
install the ribbon cartridge 1-6
introduction 1-1
parts checklist
1-2
setup, printer (continued)
prepare for installation
forms device 1-14
ribbon cartridge 1-6
printer problems 1-15
ribbon guide installation 1-8
side frames 3-23
six-part forms, using 3-18
starting a print job 3-25
states of operation 3-17
status codes and message
displays B-2
stopping a print job 3-26
T
tear bar 3-20, A-4
tension, tractor adjustment 1-39,
1-71
Tests, Operator Print 5-1
top of form position adjustment
F1 (Continuous Forms
Device) 1-46
F2 (Dual Purpose Forms
Device) 1-77
F3 (Document Insertion
Device) 1-107
tractor tension, adjustment 1-39,
1-71
training guideline A-1
transaction, preparing for next 1-79
twinaxial computer
attaching to a 2-2
V-connector, attach a 2-4
U
Unit Check indicator 3-14
unloading forms
F1 (Continuous Forms
Device) 1-51
Index X-15