Lowrance electronic Handheld Mapping GPS Receiver - Manual (Page 47)

39
2. The Transfer My Data menu includes a message which tells you if an
MMC is present or not. If no MMC is present, you must first insert a
card into iFINDER in order to activate the Load or Save commands.
To transfer data from iFINDER to the MMC: press ENT (for S AVE
.)
To transfer data from the MMC to iFINDER: press
→ to
L OAD
| ENT .
3. Saving: To accept the default name "Data" for the GPS Data File,
press
↓ to
S
AVE
| ENT . If you wish to rename the file (as in the example
below), press ENT to activate the selection box. Press
↑ or ↓ to change
the first character, then press
→ to the next character and repeat until
the name is correct. Then, press ENT |
↓ to
S AVE
| ENT .
The unit will display first a progress then a completion message when
the data transfer is finished. To return to the Page view, press
EXIT | EXIT .
From left to right, these figures show the menu sequence for naming
and saving a GPS Data File from an MMC into iFINDER's memory.
4. Loading: There may be more than one GPS Data File (*.USR) on the
card. To select a file, press
ENT to activate the selection box, use
↓ or ↑
to highlight the file, then press ENT to accept the selection. Next, press
↓ to
L OAD
| ENT . The unit will display a completion message when the
data transfer is finished. To return to the Page view, press EXIT | EXIT .
From left to right, these figures show the menu sequence for loading a
GPS Data File from an MMC into iFINDER's memory.