Step 7 set scsi terminator power – LSI MegaRAID Enterprise 1600 User Manual
Page 75
Chapter 6 Hardware Installation
61
Step 7 Set SCSI Terminator Power
J9, J10, J11, J12 These jumpers control TermPWR for the MegaRAID SCSI channels. See the documentation for
each SCSI device for information about enabling TermPWR. The factory settings supply
TermPWR from the PCI bus.
Important
The SCSI channels need Termination power to operate. If a channel is not
being used and no auxiliary power source is connected, change the jumper
setting for that channel to supply TermPWR from the PCI bus.
J9
SCSI Channel A – Short Pins 1-2 for PCI power.
J10
SCSI Channel B – Short Pins 1-2 for PCI power.
J11
SCSI Channel C – Short Pins 1-2 for PCI power.
J12
SCSI Channel D – Short Pins 1-2 for PCI power.